一共14篇文章
专题：第2期
-
奥西TDS400/450错误代码-25822
25822 The plot file is too large to plot Description The plot file is too large to plot....- 207
- 0
-
奥西TDS400/450错误代码-25824
25824 The print file is not correct Description The print file is not correct...- 209
- 0
-
奥西TDS400/450错误代码-25825
25825 The print file language is not consistant Description The print file language is not consistent. Emulation different between ALS and OJT command....- 188
- 0
-
奥西TDS400/450错误代码-25826
25826 The print language is not enabled Description The print language is not enabled....- 179
- 0
-
奥西TDS400/450错误代码-25827
25827 The print language can not be identified Description The print language can not be identified. Emulation not recognised....- 231
- 0
-
奥西TDS400/450错误代码-25828
25828 The print file consists more as one OJT Description The print file consists of more than one OJT. OJT command problem....- 240
- 0
-
奥西TDS400/450错误代码-25829
25829 The print file is split Description The print file is split. OJT command problem....- 223
- 0
-
奥西TDS400/450错误代码-25830
25830 The print file is too difficult Description The print file is too difficult. Plot failure. Tests / Checks 1 Analyse the Job as received on controller. 2 Analyse the Job as send on workstation....- 168
- 0
-
奥西TDS400/450错误代码-25831
25831 The RCF syntax is not correct Description The RCF syntax is not correct. RCF not supported / remote commands not consistent. Tests / Checks 1 Analyse the Job as received on control…...- 196
- 0
-
奥西TDS600/TDS9600错误代码-25818
25818 [FOL] Paper source in the folder has wrong format ] & Width of paper in drawer / sheetfeeder does not match measured width at second fold....- 162
- 0
-
奥西TDS700/TDS750错误代码-25833
25833 An option in the controller is not enabled Description An option in the controller is not enabled. Tests / Checks 1 Self test not OK. 2 Option not available....- 150
- 0
-
奥西PW300/350错误代码-04501 （Print head）
04501 Print head test tool error Description Fault condition: Printhead test tool sequence did not finish properly. Possible cause: Printhead not correctly adjusted in printhead tool (M&L).…...- 339
- 0
